To install the portable port expander in the cradle module,

1.Insert the portable port expander through the bottom of the cradle module as shown in Figure 2-3.

2.Position the portable port expander so you can see the portable port expander screw holes through the two holes inside the cradle module.

3.Insert the two screws (provided with the portable port expander) as shown in Figure 2-3 and tighten until snug.

Screws

Cradle

Module

Tubular Lock

Portable Port Expander

Figure 2-3. Installing the Portable Port Expander

Attaching the Feet

Using the four screws provided with the cradle module, attach the rubber feet to the back of the cradle module as shown in Figure 2-4. Tighten the screws until they are snug, do not over tighten them.

Note: The feet are only installed on the cradle module when assembling the port replicator. Do not install the feet if you are assembling the high-usage cradle, high-connectivity cradle, or wall-mount base.

Attaching the Wire Catch

The port replicator is designed for use with the FMWDS3 folding desk stand to improve viewing and usability. To secure the port replicator to the desk stand, a wire catch is provided.

Warning

Use the wire catch when using the port replicator with the desk stand. Simply leaning the port replicator on the desk stand is unstable and the pen tablet will fall.

The wire catch is a piece of spring-steel wire that is inserted in a set of holes in the back of the cradle module. You can install the wire catch in one of 3 different positions allowing you to mount the port

2-4

Assembling and Installing Connectivity Peripherals

Page 20
Image 20
Fujitsu Siemens Computers Point 500, Point 1600 manual Attaching the Feet