Furuno CH300 manual Control Unit, Blackbox type

1. MOUNTING

1.1.4Blackbox type

The blackbox type requires a VGA monitor, connected via the interface unit IF-8000. Supply commercial monitor and interconnection cable (Max. length 15 m with Dsub-15P connectors of male, three rows of 15 pins). The monitor used should satisfy the specifications shown below.

•VGA type

•ANALOG RGB 0.7 Vpp, positive polarity

•TTL level H, V, Negative polarity

Note: The LCD monitor MU-151C does not require the interface unit IF-8000. For details, see the operator’s manual for MU-151C.

1.2Control Unit

For blackbox type, fix the control unit to the mounting plate (supplied as accessories).

See the parts list of FP06-01120 and outline drawings at the back of this manual.

1.Fix the mounting plate to the place selected with two self-tapping screws (5X20, supplied).

2.Fix the bracket to the control unit with two hex. screws (M4X12, supplied).

3.Insert the screwdriver from the top of the mounting plate holes and then tighten two hex. screws (M4X12) loosely.

4.Attach the control unit to the mounting plate, and fasten two hex. screws tightly.

5.Attach two cosmetic caps to the holes at the top of the mounting plate.

Mounting plate	Cable	Fasten the screws to fix
Cable entrance hole
		the bracket.
Tapping screws (5X20)		Insert to the hex.
Bracket		screws tightened
		at step 3.
		Bracket

Cable can be passed this direction.

6. Attach hard cover to protect the control unit.

How to remove the hard cover

Place your thumbs at the locations shown with circles in the illustration at right, and then lift the cover while pressing it with your thumbs.

1-5