Furuno CH300 manual Setting of Motion Sensor/Satellite Compass, Adj motion sensor menu

3. ADJUSTMENT

3.6Setting of Motion Sensor/Satellite Compass

When connecting the motion sensor, clinometer or satellite compass, enter ship’s roll and pitch angles as shown below. Note that the adjustment can be done only when connected to the MOTION SENSOR port. For the satellite compass, however, do not duplicate this adjustment; enter values at one location only.

1.Press the MENU key to display the user menu.

2.Press to ► select SYS at the top of the menu display.

3.Press ▼ to select GO TO SYS.

4.Press ◄ to select YES.

5.Press ▼ to select ADJ MOTION SENSOR, and then press ► to display the ADJ MOTION SENSOR menu.

**ADJ MOTION SENSOR **

ROLL ANGLE:	0˚	ADJ:	+5*	˚	(-10˚ - +10˚)
PITCH ANGLE:	0˚	ADJ:	+5*	˚	(-10˚ - +10˚)

: SELECT : CHANGE MENU: END

*: For Clinometer BS-704, tilt angle is displayed. For Motion Sensor MS-100,

the readout is "0" (zero) when the ship is stopped, regardress of actual roll or pitch.

Adj motion sensor menu

6.Press ▲ or ▼ to select ROLL ANGLE or PITCH ANGLE.

7.Press ◄ or ► to adjust (-10°to +10°).

8.For MS-100, use a clinometer or other similar measuring device to measure ship’s semi-permanent inclination angle. Take the polarity of the angle. For example, if the stern is 3° down, set -3°.

+	0			–	+	0	–
			+				-
ROLL ANGLE		Starboard up				Starboard down
PITCH ANGLE		Stern up				Stern down

For clinometer BS-704, adjust so that the indication shows “0” (zero).

9. Press the MENU key several times to close the menu.

3-8