Furuno CH300 manual Monitor Unit/Control Unit, Mounting base

1.MOUNTING

NOTICE

Do not apply paint, anti-corrosive sealant or contact spray to coating or plastic parts of the equipment.

Those items contain organic solvents that can damage coating and plastic parts, especially plastic connectors.

1.1Monitor Unit/Control Unit

This searchlight sonar has two types of shipments, unibody type which is shipped with monitor unit, and blackbox type which is shipped without a monitor unit, but has an interface unit. For blackbox type, see page 1-5.

The control unit can be installed together with the monitor unit, or independently of the monitor unit. For separate installation, the optional monitor kit is required. These units can be installed on a tabletop or flush mounted in a console or panel.

1.1.1General mounting considerations

•Keep the monitor unit out of direct sunlight.

•Select a location where the unit(s) can easily be operated while observing the fishing ground or area surrounding the vessel.

•For maintenance and checking purposes, leave sufficient space at the sides and rear of the unit and leave slack in cable. (Refer to the outline drawing at the back of this manual.)

1.1.2Mounting Unibody type

1.Fasten the mounting base to the mounting location with four self-tapping screws (5X20).

FRONT

Mounting base

2.Fasten the bracket at the rear of monitor/control unit with four binding screws (M4x10).

1-1