1. MOUNTING
1.Calculate necessary length of main shaft from the length of retraction tank Lt and cut off the unnecessary portion.
Supplied length: 2.2 m or 3.8 m
Lt + 200 mm for 400 mm travel
Lt + 50 mm for 250 mm travel
|
|
|
|
|
Take care | Chamfer the edge to |
| ||
not to damage. | protect |
| ||
| damage. |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2.Remove hex bolt, nut, spring washers, flat washers and trunnion pins from the main body flange. Then, mount the raise/lower drive unit on the shaft sleeve by using the hardware removed.
|
|
| G |
|
|
| IN |
|
| N | |
| R |
| |
A |
|
| |
W |
|
|
|
WA | RN | ING |
|
|
Raise/lower drive unit
Flat Nut washer
Hex. bolt | Flange assembly | |
(M10X30) | ||
|
Spring washer
Flat washer
Trunnion pin
Shaft sleeve and raise/lower drive unit assembly
3. Pass the transducer cable through the main shaft.
