2.Remove the six flat head screws and lift the reflector out. Examine the cross-guide gaskets for wear and/or arcing; replace if there is any sign of either. Replace as described in “Replacing the RF Gasket Assembly” on page 99.

3.Refer to Figure 33 on page 95, and remove and discard the two end reflectors and the gaskets underneath. If evidence of arcing is present (dark or burned spots), clean the gasket grooves with emery cloth to remove all oxide.

Figure 33. Reflector Removal or Replacement (I330M/I311M)

Installation, Operation, and Maintenance Manual # 509252 Rev R

95