Setting the date
The default date appears in the display. The day setting is already active.
1Set the required day with the rotary selector.
2Switch to the month setting with the C symbol.
3Set the month with the rotary selector.
4Switch to the year setting with the C symbol.
5Set the year with the rotary selector.
6Confirm with ™.
'DWH
Setting the temperature format
The two possible formats °C and °F appear in the display. The °C format is selected by default.
1Set the required format with the rotary selector.
2Confirm with ™.
7HPSHUDWXUHIRUPDW
Setting the water filter
"Water filter” appears in the display. The default is "Available".
It is recommended to install the descaling system GF 111 100 if the water hardness exceeds 7°dH (carbonate hardness 5°dH).
1Use the rotary selector to select "Available" (with water filter) or "Not available" (without water filter).
2Confirm with ™.
3If water filter "Available" has been selected: "Water filter capacity” is shown in the display.
4Turn the rotary selector to select the capacity of the filter cartridge (between 100 - 9000 liters). Refer to the instructions included with the filter cartridge.
5Confirm with ™.
$YDLODEOH
:DWHUILOWHU
Setting water hardness
"Water hardness" appears in the display.
1Check the mains water with the included carbonate hardness test: fill the small measurement tube with mains water up to the 5 ml mark.
2Add drops of indicator solution until the color changes from purple to yellow.
Important: count the drops and carefully swing the measurement tube after every drop until the liquids have mixed thoroughly. The number of drops corresponds to the water hardness.
3Set the measured water hardness with the rotary selector. The value 12 is set by default.
4Confirm with ™.
:DWHUKDUGQHVV
Completing initial set-up
"Initial
16
