Water filter |
| Activating the appliance |
Operation with or without water filter |
| Standby |
You can use the appliance with or without a water filter.
It is recommended to install the descaling system GF 111 100 if the water hardness exceeds 7°dH (carbonate hardness 5°dH).
The appliance is in the standby mode when no function is set or the child lock is activated.
The control panel's brightness is reduced in the standby mode.
Change water filter
Filter cartridges should be replaced regularly. Replacement cartridges are available from
number GF 121 110).
The capacity of the filter cartridge depends on the frequency of use of the appliance and your regional water hardness. A message will appear in the display to remind you when the filter needs to be replaced. Regardless of the actual amount of water filtered the filter cartridge needs to be changed after 12 months at the latest.
1Set the function selector to S. Select "Water filter change" using the rotary selector.
2The œ symbol is displayed. Confirm with ™.
3Change the water filter. Refer to the instructions
included with the filter cartridge. Confirm with
™.
4"Select water filter capacity” is shown in the display. Confirm with ™.
5Turn the rotary selector to select the capacity of
the filter cartridge (between 100 - 9000 liters). Confirm with ™.
The water filter change is complete. Touch the ™ symbol. The appliance is now ready for operation.
Notes
‒There are various displays for the standby mode. The GAGGENAU logo and the time are set by default. Refer to the section entitled Factory setting if you would like to change the display.
‒The display's brightness depends on the vertical viewing angle. You can adjust the display by way of the "Brightness" setting in the factory settings.
Activate appliance
In order to exit standby mode, you can either
▯Set the function selector,
▯Touch a control panel,
▯or open or close the door.
Now you can set the desired function. Read the appropriate chapters to learn how to set functions.
Notes
‒If "Standby display = off" is selected in the factory setting, you must turn the function selector to exit the standby mode.
‒The standby display appears again if you have not made any settings for a long while after activation.
‒The cooking compartment lighting goes out after a little while if the door is open.
18