www.gateway.com

Adding or replacing a CD or DVD drive

Tools

You need a Phillips screwdriver to add or replace a CD or DVD drive.

To add replace a CD or DVD drive:

1Remove the side panel by following the instructions in “Removing the side panel” on page 31.

2Remove the front bezel by following the instructions in “Removing the front bezel” on page 32.

Important

The color and shape of your replacement drive’s front cover may vary from your original drive.

3If you are installing a new drive (not replacing an old one), remove the two drive retentionscrews in the drive bay, then go to Step 7. For the location of the screws, see the photo in Step 6.

4If you are replacing an existing drive, disconnect the cables from the drive, noting their locations and orientation. You will reconnect the cables after you install the new drive. (CD/DVD drive shown.)

5Note any jumper settings on the old drive and set the jumper on the new drive to be the same.

37