Installation Instructions
12 CONNECT WATER SUPPLY
Check to make sure that Master Power switch is in the O (OFF) position.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Refrigerator | House | |||||||||||||
Water Supply | Water Supply | |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•Locate and bring GE SmartConnect™ tubing to the front of the cabinet.
•Turn the water on to flush debris from line. Run about a quart of water through tubing into a bucket, then shut off water.
Copper Tubing
•Slip a 1/4″ nut and ferrule onto end of copper tubing. Insert tube into the union fitting on the unit and tighten nut to union.
•Turn on the water to check for leaks.
GE SmartConnect™ Tubing
•Insert the molded end of the tubing into the refrigerator connection. Tighten the compression nut until it is just hand tight.
•Tighten one additional turn with a wrench.
Overtightening can cause leaks.
•Turn on the water to check for leaks.
Note: Make sure excess tubing length does not interfere with toekick installation.
13TURN ON THE POWER
•Set the Master Power switch to the I (ON) position.
•Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on.
Raise
Grille
Panel
Master | Water Filter |
Power Switch |
|
•The temperature controls are preset at 37° for the Fresh Food section and 0° for the Freezer section.
•Allow 24 hours to stabilize before making adjustments.
34