OWN CONTROL, CLOCK Am T~ER
Clock
The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be chunged during a Timed Baking or
To Set tie Clink
1.Press the CLOCK pad.
CLOCK
nA
2.Press the INCREASE or DECREASE pad [() set the time of day.
@
A
Timer
The timer is a minute timer: it does not c[)ntm)l oven operati{)ns. The maximum setting on the timer is 9 hours and 55 minutes.
To Set tie Timer
1. Press the TIMER
❑~l~o$p ON/OFF pad.
A
2. Press the INCREASE or DECREASE pad
Qto set the amount of
A time on the [imcr.
e
v
The timer will start automatically
within a fcw seconds of releasing the
INCREASE or DECREASE pad. The
timer, as you m .setiing it, will display seconds until one minute is re:~chcd. Then it will display minutes and seconds until H) minutes is reached.
Atir ti) minutes, it will display hours (“HR” now appears in display) and minutes until the maximum time of 9 hours and 55 minutes is reached.
To Reset tie Timer | To Cancel tie Timer |
If ‘TIMER” is displayed, press the INCREASE or | Press and hold the TIMER ON/OFF pad until the |
DECREASE pad until desired time is reached. | word ‘.TIMER”’ disappears from the display. |
If “TIMER” is not displayed, press the TIMER |
|
ON/OFF pad first, then f(~llow the instructions akve |
|
tf) set the timer. |
|
End of Cycle Tone
The end of cycle tone is a series of three beeps followed by one beep every six seconds. If you would like to remove the signal that beeps every six seconds, press and hold the CLEAWOFF pad for 10 seconds.
To return the signal that beeps every six seconds, press and hold the CLEAWOFF pad for 10 seconds.
Display Messages
●If “clean” appeam in the display, DOOR Ilashcs and the oven control signals, yt)u set the
s If “~~’ ody ap~ in tie dispky, the oven door is in the locked position. BAKE, BROIL and COOK TIME cannot be set if the door is in the locked positiun.
Power Outage
After a power outage, when power is restored, the display will flash and time shown will no longer be
The display flashes until the clock is reset. All other functions that were in operation when the p)wer went out will have to be programmed again.
14