Installation Instructions
J
Making the L.P. Gas Conversion
J6
Air Shtter Setting for Bake and Broil Burners
1.Use a screwdriver to loosen the air shutter screw.
2.Adjust the air shutters. The table below gives the recommended initial air shutter setting. Your final settings may vary.
INITIAL AIR SHUTTER SETTINGS
Gas Supply | Location | Dim. “A” |
LP Gas | Broil burner | 7/16" |
| Bake burner | 5/16" |
Natural | Broil burner | 5/16" |
| Bake burner | 3/16" |
Dim. “A”
(Adjust at the opening nearest the air shutter screw.)
Air Shutter
Adjustment Screw
3.Retighten the air shutter screw.
Bake and broil flame must be checked with the door closed to properly check flame characteristics.
4.Turn on the bake or broil burner.
a.If the flames are yellow, open the air shutter more.
b.If the flames blow away or flutter from the burner close the air shutter more.
WARNING: If you attempt to measure the inner cone of the flame, please use caution; burns could result.
5.Checking the flame size.
Check the inner cone | Inner Cone of Flame | |||
|
|
|
| |
of the flame. It should | 1/2" To 3/4" |
| Oven Broiler | |
| ||||
be approximately 1/2" |
|
|
| |
|
|
| Burner | |
to 3/4" long for the |
|
|
|
|
oven and broil burners. |
|
|
|
|
|
|
|
| |
If the flame size is incorrect, recheck all conversion steps.
“A” | “B” | “C” |
YELLOW FLAMES | SLIGHT YELLOW | SOFT BLUE FLAMES |
Call for Service | TIPPING | Normal for Natural Gas |
| Normal for LP Gas |
|
6.When all adjustments are made and the results are satisfactory:
a.Replace the orifice fitting cover
b.Replace the oven baffle (flame spreader)
c.Replace the oven bottom.
IN SOME CASES
1.With L.P. gas, some yellow tipping on the outer cone is normal.
2.Foreign particles in the gas line may cause an orange flame at first, but this will soon disappear.
SPECIAL NOTE:
To convert the oven back to natural gas, reverse the instructions given in making L.P. Adjustments.
Once the conversion is complete and checked ok, fill out the L.P. sticker and include your name, organization and date
conversion was made. Apply the sticker to the range near the regulator to alert others in the future that this appliance has been converted to L.P. If converting back to natural gas from L.P., please remove the sticker so others know the appliance is set to use natural gas.
17
