Operating the DVI KVM over IP
Unicast and Multicast Modes
3.Click the Unicast button under the Network Mode group. When selected, the Unicast button will be highlighted in blue.
4.Click the Save button in the
5.The following message will be displayed, at the top of the page, indicating that the casting mode has been applied to the Sender or Receiver unit.
6.Click the Reboot button near the bottom portion of the page to apply the changes.
7.Repeat steps 1 - 6 in order to configure the Sender unit to unicast mode.
IMPORTANT: When switching between unicast and multicast modes, both Sender and Receiver units need to be configured identically.
page 21
