Operating the DVI KVM over IP
USB Control
Assigning USB control under Active per request mode
1.Press and hold the Switch button on the desired Receiver unit, for at least two seconds. In this example, we will depress the Switch button on Receiver unit R1.
2.The message “Starting USB” will appear on the connected display.
Figure 2.11 - Receiver unit R1 has USB control.
DVI Out
Receiver unit
LAN
| R |
| 2 |
DVI Out | Receiver unit |
|
| R | 07 |
| Sender unit |
| 1 |
|
| |
|
|
| S | |
07 |
|
|
| 2 |
| Sender unit |
|
| |
|
| S | 07 | USB cable |
|
| 1 |
|
|
DVI In
05
Sender unit
S3
DVI In
09
DVI In
3.In order to assign USB control to a different Receiver unit, repeat steps 1 - 2
IMPORTANT: If switching between Active per request mode and Active on link mode, the Save and Reboot buttons must be clicked to apply changes.
page 34
