Update USB Module Software

1.Remove shroud. See Remove Shroud.

2.Use software token 16A265. See Graco Control ArchitectureModule Programming manual for instructions.

NOTE: Upgrade all modules in the system to the software version on the token, even if you are replacing only one or two modules. Different soft- ware versions may not be compatible.

All data in the module may be reset to factory default settings. Record all settings and user prefer- ences before the upgrade, for ease of restoring them following the upgrade.

The latest software version for each system can be found at Tech Support at www.graco.com.

Repair

Replace USB Module

1.Remove shroud. See Remove Shroud.

2.Disconnect power.

3.Remove four nuts (4); leave two nuts on left side of panel tight. Open front panel of control box (11).

4.Disconnect CAN cables and USB cable from USB module (219).

5.Remove two mounting screws from USB module and remove module from base.

r_312359_313289_23a

219

6.Follow steps in reverse order to install new USB module.

7.Load software. See Update USB Module Soft-

ware.

313289S

33

Page 33
Image 33
Graco 313289s Update USB Module Software, Replace USB Module, Load software. See Update USB Module Soft Ware