Installing Blade
Guard
The blade guard assembly consists of four pieces: Lower and upper support arms, a pivoting swing arm and a clear plastic blade guard shield.
To install the blade guard:
1.Remove the six bolts from the side of the motor cabinet.
2.Position the lower support arm over the holes on the side of the motor cabinet and secure it with the bolts and lock washers removed in step 1, so the assembly looks similar to
Figure 31.
Lower Support
Arm
Figure 31. Lower support arm installed.
3.Unthread the eight bolts from the upper sup- port arm.
4.Position the upper support arm over the holes in the lower support arm and secure it with the bolts removed in step 3 (Figure 32).
Upper
Support Arm
Figure 32. Vertical support installed.
5.Loosen the pivot bolt (Figure 33) at the end of the swing arm to position the steel mount- ing brace over the end of the upper support arm.
Steel Mounting | Pivot Bolt |
Brace |
|
| Pivoting Swing |
| Arm |
Figure 33. Pivot bolt.
6.Position the pivoting swing arm over the saw table (Figure 34) and secure it with four
G0501 Sliding Table Saw |
