Dust Collection

The Model G0501 is equipped with two dust ports that should be properly connected to a dust col- lection system before operation.

To connect the dust ports to a dust collection system:

1.Secure a 5" dust hose to the dust port locat- ed under the saw table (Figure 59).

Figure 59. 5" dust port location.

2.Run the 5" hose to your dust collection sys- tem.

3.Connect a 2" dust hose to the port located above the blade guard shown in Figure 60.

Figure 60. 2" dust port location.

4.Run the 2" hose along the braces on the back of the blade guard swing arm to your dust collection system. Make sure to leave extra slack in the dust hose near swing arm pivot points.

NOTICE

Remember maximum working clearances when installing dust hoses.

5.Run a ground wire along the dust hose and attach the wire to the machine to protect against static electricity.

-36-

G0501 Sliding Table Saw

Page 38
Image 38
Grizzly G0501 instruction manual Dust Collection, To connect the dust ports to a dust collection system