Grizzly G0501 instruction manual Crosscut Table, To assemble the crosscut table

7.Check if the bottom edge of the aluminum fence piece rests on the top surface of the table. Note—The aluminum fence piece will scratch the table surface if the ride height is not adjusted correctly.

—If the bottom edge of the aluminum fence piece does not rest on the table, then fence is correctly adjusted. Proceed to the next sub-section.

—If the bottom edge of the aluminum fence piece does rest on the table, then contin- ue on to the next step.

8.Loosen the cam bolt located on the end of the fence clamp assembly (see Figure 45).

Figure 45. Installed clamp assembly.

9.Rotate the cam up or down to adjust the ride height of the fence.

10.Retighten the cam bolt and check the ride height. Re-adjust if necessary.

Crosscut Table

To assemble the crosscut table:

1.Swing the crosscut table brace away from the table saw base. Note—A magnet holds the support against the base. A strong pull is necessary to free the support.

2.Position the brace perpendicular to the long edge of the sliding table.

3.One end of the crosscut table has a clamp- ing assembly designed to attach to the bar on the sliding table. The two cap screws (Figure 46) located under the clamp need to be backed out far enough to allow the clamp to slip over the bar on the sliding table.

Figure 46. Cap screws used to secure the

crosscut table clamping assembly.

4.Lift the crosscut table and slip the clamp over the bar on the sliding table and set the other end of the crosscut table onto the shaft that protrudes up from the brace (Figure 47).

-30- G0501 Sliding Table Saw