2.Remove the three cap screws, lock washers and flat washers from the side of the table (Figure 38, white arrows) and remove the two cap screws from the motor cabinet (Figure 38, black arrows).
6.Check the surfaces of the table with a straight edge a shown in Figure 40.
Figure 38. Hardware location for small table.
3.Position the small extension table over the holes on the cast iron table and secure it with the three cap screws that you removed in step 2 (Figure 39). Note—Get assistance positioning the table and holding it in place while installing.
Cap Screws
Adjustment Screws
Figure 39. Small extension table installed.
4.Use the adjustment screws (Figure 39) under the extension table to level the top sur- face with the saw table.
5.When the surfaces are level, slide the table supports against the machine frame and secure them with the cap screws.
Figure 40. Checking with a straight edge.
7.Position the adjustment screws between the table support braces and extension table to finely tune the table so it is level.
8.To install the large extension table, move to the back of the saw and remove the four cap screws from cast iron table and the four cap screws from the cabinet.
9.With the help of at least two assistants, install and level the large extension table in the same manner as the small extension table, using the hardware removed in step 8. Figure 41 shows the large extension table installed correctly.
Figure 41. Large extension table installed.
G0501 Sliding Table Saw |
