To change the belt on the scoring blade motor:
1.Move the blade tilt to 0˚ on the control panel (blade 90˚ to table), and raise the main blade and scoring blade set up as far as they will go.
2.Disconnect the saw from the power source!
3.Open the motor cabinet door.
4.Jack up the scoring blade motor with a bottle jack, as shown in Figure 91, to loosen the belt.
Calibrating Blade
Tilt
The blade tilt is calibrated at the factory, but can be adjusted if it changes during the life of the machine.
To calibrate the blade tilt:
1.Move the blade tilt to 0˚ on the control panel (blade 90˚ to table), and raise the main blade as far as it will go.
2.Place a machinist’s square on the table and against the blade.
3.Adjust the blade tilt until the blade is perfect- ly square with the table.
4.At the control panel, press SET.
5.Press 0.
Figure 91. Jacking up scoring motor with a bot-
tle jack to remove the belt.
5.Remove the old belt and install a new belt in the center of the pulleys.
6.Let the jack down, so the weight of the motor tensions the belt.
7.Remove the jack and wood blocks, and close the motor cabinet door.
6.Press and hold down SET for five seconds. This new setting will now be stored in the control panel.
G0501 Sliding Table Saw |
