Grizzly G0554Z owner manual Gearbox Controls Carriage Controls & Components, On/Off

Gearbox Controls

Carriage Controls & Components

F

G

H

I

J

K

L

M

Y

X W

V

N

T

U

O

P

Q

R

S

Figure 19. Gearbox controls.

F.Feed Lock Knob: Engages/disengages the power feed and the feed rate knobs.

G.Numeric Feed Rate Knob: One of three controls for setting the feed rate.

H.C-F Feed Rate Knob: One of three controls for setting the feed rate.

I.STOP Button: When pushed, turns the spin- dle motor and coolant pump OFF. To reset this button, twist it clockwise until it pops out.

J.Jog Button: When pushed, starts counter- clockwise spindle rotation.

K.Power Lamp: Lights when the machine is connect to power and the main power switch is turned ON.

L.Coolant Switch: Turns the coolant pump

ON/OFF.

NOTICE

Running the coolant pump without adequate coolant in the tank may permanently damage the coolant pump motor. This is considered abuse and is not covered by the warranty.

-22-

Figure 20. Carriage controls.

M.Compound Slide: Moves in-and-out across the spindle center line. The compound slide is adjustable for any angle within its range, which is adjusted by using the hex nuts and angle scale on the base of the slide.

N.Compound Handwheel: Moves the com- pound rest in increments of 0.001" or 0.02mm and is used to control the position of the cut- ting tool relative to the workpiece. Turning the handwheel clockwise moves the slide toward the workpiece. The graduated dial can be adjusted by holding the handwheel with one hand and turning the dial with the other.

O.Carriage Lock: Secures the carriage in place for greater rigidity and accuracy when cutting.

P.Thread Dial: Shows when to engage the half-nut during threading operations.

Q.Thread Dial Chart: Indicates on which thread dial reading to engage the half-nut for specific inch thread pitches.

R.Half-Nut Lever: Engages the half-nut for longitudinal power feed and threading opera- tions.

S.Spindle Lever: Starts, stops, and reverses direction of spindle rotation.

T.Power Feed Lever: Engages the power feed for longitudinal or cross travel.

Model G0554Z (Mfg 01/09+)