SECTION 3: SETUP
Preparation
The list below outlines the basic process of pre- paring your machine for operation. Specific steps are covered later in this section.
The typical preparation process is as follows:
1.Unpack the lathe and inventory the contents of the box/crate.
2.Clean the lathe and its components.
3.identify an acceptable location for the lathe and move it to that location.
4.level the lathe and bolt it to the floor, or place it on leveling pads.
5.assemble the loose components and make any necessary adjustments or inspections to ensure the lathe is ready for operation.
6.Check lathe for proper lubrication.
7.Connect the lathe to the power source.
8.Test run lathe to ensure it functions properly.
9.perform the spindle
Unpacking
Your machine was carefully packaged for safe transportation. Remove the packaging materials from around your machine and inspect it. If you discover any damage, please call us immediately at (570)
Save the containers and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi- tion of your shipment, inventory the contents.
SUFFOCATION HAZARD!
Keep children and pets away from plastic bags or packing materials shipped with this machine. Discard immediately.
Needed for Setup
The following are needed to complete the setup process, but are not included with your machine.
•For Lifting and Moving:
•For Power Connection:
•For Assembly:
Model G0746/G0749 (Mfg. Since 3/13)
