To connect lathe to power:
1.Make sure the main power switch on the lathe electrical cabinet is turned to the OFF position, then open the door.
2.Insert the incoming power wires through the opening shown in Figure 23.
Opening for
Incoming Power
Figure 23. Location of opening in electrical
cabinet for incoming power.
3.Connect the incoming hot wires to the L1, L2, and L3 terminals, shown in Figure 24. Connect the incoming ground to the ground- ing terminal (PE).
L3 
L2 
L1 
PE
Figure 24. Location to connect incoming hot
wires and ground wire.
4.Make sure the wires have enough slack so they are not pulled tight or stretched.
5.Close the main electrical cabinet door.
Test Run
Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.
The test run consists of verifying:
•the motor powers up and runs correctly.
•The motor turns in the correct direction (machine is not wired out of phase).
•the safety features work correctly.
•the brake system works correctly.
•the coolant system works correctly.
If you notice an unusual noise or vibration, stop using the machine immediately, and remedy before operating it further.
Before starting the lathe, make sure you have performed the preceding assembly and adjustment instructions, and you have read all the documentation provided with the lathe and are familiar with the various func- tions and safety features on this machine. Failure to follow this warning could result in serious personal injury or even death!
To test run your machine:
1.Make sure the main power switch (see Figure 25) is turned OFF.
Main Power
Switch
