Grizzly g0746, g0749 owner manual Assembly, Location of headstock jack screws

—If using the included leveling pads (see Figure 19), thread the leveling bolts with the hex nuts into the bottom of the stand, place the pads under the bolts, then adjust them to level the machine.

Leveling Bolts

x 8

Pads

Figure 19. Leveling pads, bolts (hex nuts not

shown).

For additional leveling, use the jack screws under the headstock and tailstock (see Figures 20 and 21). To access the tailstock-end jack screws, remove the coolant motor cover.

Jack Screws

Figure 20. Location of headstock jack screws.

Assembly

With the exception of the carriage handle and cross slide handwheel, the lathe is shipped fully assembled.

Use a 5mm hex wrench to thread the carriage handle into the carriage handwheel.

Slide the cross slide handwheel onto the shaft and secure it with the included tapered pin, as shown in Figure 22.

Cross Slide

Handwheel

Tapered Pin

Carriage Handle

Figure 22. Handwheel handles installed.

Jack Screws

Figure 21. Tailstock-end jack screws.

—if using mounting hardware that does not allow for adjustment, level the lathe by placing metal shims between the lathe base and the floor before anchoring it.

-26- Model G0746/G0749 (Mfg. Since 3/13)