CUSTOM SETTINGS _____________________
Switching the screen saver on and off
SETUP MENU – PREFERENCES
Rating Level
Change Password
Restore factory settings
Screensaver
SCART output
Default Source
a
Remote Control Type
Off
OK
OK
On
RGB
Radio
DVD Recorder
When this function is activated, the screen saver starts when no function has been selected on the HDD DVD recorder for some time.
1Press »SET UP« to open the setup menu.
2Select
3Select »Screensaver« with »S« or »A« and press »OK« to confirm.
4Select the function with »S« or »A« (»ON« or »OFF«) and confirm with »OK«.
5Press »SET UP« to finish the setting.
Setting the signal type for the video output socket
SETUP MENU – PREFERENCES
Rating Level
Change Password
Restore factory settings
Screensaver
SCART output
Default Source
a
Remote Control Type
Off
OK
OK
On
RGB
Radio
DVD Recorder
The video output of your HDD DVD recorder was set at the factory to »RGB«.
If you connect your HDD DVD recorder to a television, flat screen or projector using cinch cables (»Y«, »Pb/Cb« and »Pr/Cr« of the HDD DVD recorder), you must set the video output correctly so that the television receives the video signal and therefore the picture.
1Press »SET UP« to open the setup menu.
2Select
3Select »SCART output« with »S« or »A« and press »OK« to confirm.
4Select the video output with »S« or »A« and press »OK« to confirm.
–»RGB« for the »EURO AV1 ➞ TV« socket,
»YUV« for the sockets »Y«, »Pb/Cb« and »Pr/Cr«, »Y/C« for the »EURO AV1 ➞ TV« sockets or
»S-VIDEO OUT«.
»Video« for the »EURO AV2 ➞ TV« or »VIDEO OUT« sockets.
5Press »SET UP« to finish the setting.
Notes:
The »YUV« setting is a precondition for interlace and progres- sive mode. If it has been selected, you can use »I/P« to switch between the two output formats. You can also do this using the setup menu.
In progressive mode the »VIDEO OUT« and
ENGLISH
95