Hand Held Products 3700 CCD manual Default Operating Parameters, Default Configuration Settings

4.6Default Operating Parameters

The SCANTEAM 3700 is configured at the Hand Held Products factory with standard (default) operating parameters. The default configuration can be used as is or changed (reconfigured) by downloading new parameters over an RS–232 communications line from a host instrument. The default configuration settings are listed below.

Default Configuration Settings

•	ACK / NAK	Disabled
•	Baud Rate	9600
•	Beeper Mode	Disable beeper
•	Data Bits	7
•	No Read Message	“NR”
•	Parity	Even
•	Postamble	CR LF
•	Preamble	Port ID Code ID
•	Read Timeout	Timeout ends a read attempt, 1.5 seconds
•	RTS/CTS	Disabled
•	Stop Bit	1
•	Trigger Mode	Serial Trigger or External Trigger, Read Once
•	Votes	Voting set to 3 for port 1 and set to 1 for port 2
•	XON/XOFF	Disabled
Default Configuration: Symbology Settings
•	Codabar	Enabled
	Send Start/Stop	Yes
	Minimum Length	6
	Maximum Length	60
•	Code 39	Enabled
	Require Checksum	No
	Send Checksum	No
	Minimum Length	1
	Maximum Length	48
•	Code 128	Enabled
	Minimum Length	1
	Maximum Length	80
• I 2 of 5		Disabled
	Require Checksum	No
	Send Checksum	No
	Minimum Length	6
	Maximum Length	80
• UPC A/E, EAN 8/13		Enabled

4–16 Configuring the SCANTEAM 3700