Hand Held Products 3700 CCD manual SCANTEAM 3700 Removal/Replacement

The following information is required to process an RMA for the product and should be available for the Service Representative. It is located on the manufacturers label attached to the box the SCANTEAM 3700 was shipped in.

Model Number

Serial Number

Date of Manufacture

Note: The Welch Allyn Customer Service Group cannot accept materials that are returned without an RMA number.

When out of warranty service is required the Customer Service Representative will request a Purchase Order Number in the amount of the “not to exceed” price for repair. However, customers will be billed only for the actual service costs.

5.4SCANTEAM 3700 Removal/Replacement

	The application intention of the 3700 makes it a component of the host controlled
	instrument. Power to the host system must be turned off before removing the 3700
	Machine Mount CCD. Removing the 3700 involves reversing the steps that you
	followed during installation (Chapter 3).
Caution:	Some circuits in the 3700 Machine Mount CCD are sensitive to electrostatic
	discharge. Be sure you are properly grounded before removing the 3700 from the
	host system.
Note:	Set the host instrument power switch to the “OFF” position.
	Step 1: Disconnect the data communications/power cable between the 3700 Machine
	Mount CCD and the host system (see Chapter 2, Figure 2.2 for the exact
	location of the port on the 3700).
	Step 2: Using a screwdriver, remove the mounting screws, if applicable, from the 3700
	Machine Mount CCD.
	Step 3: Remove the 3700 Machine Mount CCD and place it immediately into an
	antistatic container or an antistatic bag.
	This completes the 3700 Machine Mount CCD removal procedure. For replacement
	vinstructions, please follow the set–up and installation procedures in Chapter 3.

Service/Technical Assistance 5–5