Only For Qualified Installers
Blower Assembly Ready to Install.
INSTALLATION (Options)
6.Place the blower assembly into the blower box. You may need to tilt the assembly to get it through the opening in the blower box. Make sure the wires do not get pinched.
7.Install finished flooring, carpet, tile, etc.
8.Install register by sliding it down into the opening. Make sure the speed control door is over the speed control. The register is designed to allow for a variation in floor thickness.
9.Turn on electrical power and test.
| Operation: |
Blower Assembly Installed. | Note: A temperature switch on the fireplace will |
| not allow the register blower to start if the |
| fireplace is not warm enough to blow hot air. |
| This same switch will turn the blower off, if |
| the fireplace is turned off and cools. |
| 1. Open the speed control door and turn the blower |
| on to the desired speed. Turning the blower on, |
| opens the damper in the top of the fireplace and |
| allows hot air to flow. |
| 2. Close the speed control door. |
Speed Control
Knob
Under Floor View
34