Only For Qualified Installers | INSTALLATION (Options) |
Thermostat
Front Burner
Button
Rear Burner
Button
Connecting the
Optional Thermostat
If the optional thermostat is used, it must be plugged into the terminal strip located in the lower left front corner of the heater.
When installing a millivolt control system, use only a special low resistance thermostat. DO NOT USE A REGULAR HEATING THERMOSTAT.
Be sure that all electrical connections are clean, free from corrosion, and tight. Inspect connections periodically to confirm that no corrosion has built up over time.
When properly installed and maintained, a mil- livolt control system should give many years of
It is important to use wire of a gauge proper for the length of the wire:
RECOMMENDED WIRE GAUGES
Maximum | Wire |
Length | Gauge |
100' | 14 |
60' | 16 |
40' | 18 |
25' | 20 |
15' | 22 |
Remote Control
The front button on the remote control can be used to turn the front burner on and off. The rear button is used to turn the rear burner on and off.
This remote uses the ultrasonic control method and does not need to be pointed directly at the fire- place.
A hand held sending unit, receiving unit, mount- ing bracket and all wiring are included when you order the remote control.
Installation instructions are packed with remote
kit.
28