7 Appliance Preparation
CAUTION
Sharp Edges
•Wear protective gloves and safety glasses dur- ing installation.
A. Installing Outside Air Kit Damper Assembly
| WARNING |
|
|
| Asphyxiation Risk. |
| Figure 7.2 Outside Air Kit Installation |
|
|
| |
| Fire Risk. | • Attach damper assembly to appliance using screws | |
| Do NOT draw outside combustion air from: | ||
| • Wall, floor or ceiling cavity. |
| provided (see Figure 7.2). |
| • Enclosed space such as an attic or garage. | • | Insert narrow end of handle through tab and into upper |
| • Close proximity to exhaust vents or chimneys. |
| slot of door. |
| Fumes or odor may result. | • | Check handle operation. Pull handle out to open, and in |
|
| ||
|
|
| to close. |
• | Remove and discard cover plate or knockout from side | B. Gas and Electrical Connections | |
| of appliance. | ||
• | Open air kit damper slightly. | If applicable, ensure that gas and electrical connections are | |
• Locate door hinge toward back of appliance (see Figure | installed at this time. Refer to Sections 9 (Gas Information) | ||
| 7.1). | and 10 (Electrical Information). | |
DOOR |
HINGE |
HANDLE |
Figure 7.1 Damper Assembly and Handle |
16 | Heat & Glo • |
