12 Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the firebox.
B. Remove Grate Shipping Support
•Remove the log pack and hood, if applicable.
•Bend top retaining tab of grate shipping support into vertical position (see Figure 12.1).
•Lift grate slightly upward with one hand so that the grate clears the support.
•Slide shipping support to side, remove and discard.
•Lower grate onto refractory.
Figure 12.1
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included with accessories. See Service Parts List for appropriate acces- sories. Refer to Section 16.
WARNING
Shock or fire risk.
Use ONLY optional accessories approved for this appliance.
•Using
•Using
•Only Hearth & Home Technologies approved accessories may be used safely.
E.Install the Refractory
F.Lava Rock, Vermiculite, Rockwool/ Ember Placement
WARNING
Explosion Risk.
•Follow ember placement instructions in manual.
•Do NOT place embers directly over burner ports.
•Replace ember material annually.
Improperly placed embers interferes with proper burner operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place the ember material:
•When placing Glowing Embers® onto the burner care should be taken so that the ports are not covered. Place the
•Save the remaining ember materials for use during appliance servicing. The embers provided should be enough for 3 to 5 applications.
Figure 12.2 Placement of Embers |
Heat & Glo • | 25 |
