Heat & Glo LifeStyle SL-750TV-D, SL-950TV-IPI-D, SL-950TV-D, SL-550TV-D Junction Box Installation

E. Junction Box Installation

If the box is being wired from the OUTSIDE of the appliance:

•Remove the cover plate located on the outer shell right side (see Figure 10.4).

•Install the supplied Romex™ connector in the cover plate.

•Feed the necessary length of wire through the connector.

•Make all necessary wire connections and reattach the cover plate to the outer shell.

If the box is being wired from the INSIDE of the appliance:

•Remove the screw attaching the junction box/recep- tacle to the outer shell, rotate the junction box/recep- tacle inward to disengage it from the outer shell (see Figure 10.4).

•Pull the electrical wires from outside the appliance through this opening into the valve compartment.

•Feed the necessary length of wire through the connector.

•Make all necessary wire connections to the junction box/receptacle and reassemble the junction box/ receptacle to the outer shell.

	Romex
	Connector
	14/2WG
	Cover Plate
	outside firebox
WHT
BLK
WHT
BLK	Copper
GRN wire	ground attached
	to GRN screw with
inside box	GRN wire
	NOTE: Do NOT wire
Figure 10.4 Junction Box Detail	110VAC to wall switch.

F. Wall Switch Installation for Fan (Optional)

If the box is being wired to a wall mounted
switch for use with a fan (See Figure 10.5):
•	The power supply for the appliance must				SWITCH
	be brought into a switch box.	MINIMUM 14-3 AWG
		WITH GROUND
• The power can then be supplied from the				Red
	switch box to the appliance using a mini-			Black	Black
	mum of 14-3 with ground wire.			White	White
				Green	Green
•	At the switch box connect the black (hot)	JUNCTION BOX		Green
		Red	Black White
	wire and red (switch leg) wire to the wall
	switch as shown.				POWER
					SUPPLY WIRES
•	At the appliance connect the black (hot),				SWITCH BOX
	white (neutral) and green (ground) wires
	to the junction box as shown.
•	Add a 1/4 inch insulated female connector
	to the red (switch leg) wire, route it through	Red
	the knockout in the face of the junction box,
	and connect to the top fan switch connector
	(1/4 inch male) as shown.	Figure 10.5 Fan Control Switch Wiring
	Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. J • 4/07				23