13 Operating Instructions
A. Before Lighting Appliance
Before lighting this appliance determine if it has a Standing Pilot or Intellifire ignition system by opening the control access panel to view wiring system and gas valve. If this appliance has a red or black ignitor button (see Figure 10.1) this appliance has a Standing Pilot ignition system. If there is no red or black ignitor button, this appliance has an Intellifire ignition system.
CAUTION
If installing Intellifire ignition battery backup:
•Do not install batteries if the backup mode may not be used for extended time.
•Batteries may leak.
•Install batteries only when needed for power outage.
Before operating this appliance have a qualified technician:
•Remove all shipping materials from inside and/or underneath the firebox.
WARNING
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
Glass and other surfaces are hot during operation and cool down.
• Keep children away.
• CAREFULLY SUPERVISE children in same room as appliance.
•Alert children and adults to hazards of high temperatures.
•Do NOT operate with protective barriers open or re- moved.
•Keep clothing, furniture, draperies and other combustibles away.
This appliance has been supplied with an integral barrier to prevent direct contact with the fixed glass panel. Do NOT operate the appliance with the protective barrier removed. Contact your dealer or Hearth & Home Technologies if the barrier is not present or help is needed to properly install one.
•Review proper placement of logs, rockwool, lava rock, and vermiculite.
•Check the wiring.
•Check the air shutter adjustment.
•Ensure that there are no gas leaks.
•Ensure that the glass is sealed and in the proper position.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or the gas supplier.
• | Ensure that the flow of combustion and ventilation air is | B. Check Appliance Draft |
| |
| not obstructed (front grilles and vent caps). | Check draft of appliance to |
| |
|
|
| DRAFT HOOD | |
|
|
| verify proper venting condi- | |
|
| WARNING |
| |
|
| tions. |
| |
| Glass door must be in place when | • Close all windows and |
| |
| doors, turn on all exhaust |
| ||
| appliance is operating. Risk of: |
| ||
| fans in home. | FLAME UP | ||
| • | Combustion Fumes | ||
| • Appliance is to be com- | - ACCEPTABLE - | ||
| • | Fire |
| |
| Do NOT operate appliance with glass door removed. | pletely assembled to nor- |
| |
| • Open viewing glass for servicing only. | mal operating condition. |
| |
| • Turn on appliance and al- |
| ||
| • Glass door MUST be in place and sealed before operating |
| ||
| appliance. |
| low to operate for at least |
|
| • Only use glass door certified for use with appliance. | 10 minutes. |
| |
| • Glass replacement should be done by qualified | • Check draft as shown in | FLAME IN | |
| - GOOD - | |||
| technician. |
| Figure 13.1. This can be | |
|
|
| ||
|
|
| done using a smoke or |
|
|
| WARNING | flame producing match. |
|
|
| • Hold lit match at bottom |
| |
| Do NOT use this appliance if any part has been under water. | edge of draft hood opening |
| |
| and observe flame/smoke |
| ||
| Immediately call a qualified service technician to inspect the |
| ||
| per the figure. | FLAME OUT | ||
| appliance and to replace any part of the control system and | |||
|
| - BAD - | ||
| any gas control which has been under water. | Figure | 13.1 | |
|
| Heat & Glo • | 31 | |
