Heat Controller DMC24CA-1 Settlement of outdoor unit, Indoor Unit Installation, Tubing connection

Installation

2. Settlement of outdoor unit

• Anchor the outdoor unit with a bolt and

nut(ø 10mm(0.39inch)) tightly and horizontally on a
concrete or rigid mount.		Tubing connection
• When installing on the wall, roof or rooftop, anchor	Bolt
the mounting base securely with a nail or wire assum-
ing the influence of wind and earthquake.

• In the case when the vibration of the unit is conveyed to the hose, secure the unit with an anti-vibration rub- ber.

3. Indoor Unit Installation

Hanging bolt

(W3/8 or M10)

Nut (W3/8 or M10)

Spring washer (M10)

Flat washer for M10				Air Conditioner body		150mm(5.91inch)
					Ceiling
Keep the length of the bolt
from the bracket to 40mm(1.57inch)
	(accessory)
		Ceiling board				Ceiling board
Flat washer for M10
	(accessory)		Paper model		Set screw of
Nut
			for installation		paper model (4 pieces)

(W3/8 or M10)
Adjust the same height	Open the ceiling board
	along the outer edge of the
	paper model

• The following parts is option.

Hanging Bolt	- W 3/8 or M10
Nut	- W 3/8 or M10
Spring Washer - M10
Plate Washer	- M10

CAUTION

• Tighten the nut and bolt to prevent unit falling.

•Drill the piping hole on the wall slightly tilted to the outdoor side using a Ø 70(2.76inch) hole-core drill.

Wall

Indoor	Outdoor
5~7mm	(0.20~0.28inch)

22Ceiling Cassette Air Conditioner