Heatiator HEIR42T Appliance Preparation, A. Vent Preparation, Seal Cap Gasket, Logs, Finishing

9 Appliance Preparation

A. Vent Preparation

CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.

NOTICE: This appliance is top vented ONLY.

1.Remove shrink wrap from appliance. Figure 9.1 shows the shipping location of the seal cap and heat shields (Section 9), splatter guard and finishing templates (Section 13), and the lava rock and logs (Section 14).

2.Remove seal cap from top of appliance by removing one screw, which is included, to prevent construction material from getting into appliance. Remove seal cap when pipe installation phase begins. See Figure 9.2.

3.Ensure gasket seal is in place prior to installing vent pipe sections. Gasket is installed at the factory.

SEAL CAP

GASKET

Figure 9.2 Seal Cap and Gasket Location

SEAL CAP	LOGS	FINISHING
SPLATTER GUARD		TEMPLATES
		(NOT SHOWN)

LAVA ROCK

HEAT SHIELDS

Figure 9.1 Shipping Location of Components

Heatilator • HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12 37