Heatiator HEIR50H, HEIR42H, HEIR42T A. Finishing Templates, Template installation instruction

13 Finishing

A. Finishing Templates

Two side finishing templates and one top finishing template are supplied with the appliance. They are fastened to the top surround.

INSIDE FIT Method: The finishing template pieces are required for installations that require more than one inch thick finishing materials to be installed over the face of the factory-supplied 1/2 inch non-combustible board. Refer to section 13.E for more information.

OVERLAP Method: The supplied templates are not required for finishing materials less than one inch thick. The required decorative front will overlap finish materials less than one inch thick. Refer to section 13.E for more information.

Note: For Arch Door applications with finish material greater than one inch thick, an Arch Template Kit is available. Contact your dealer to order the arch template kit.

Template installation instruction

1.Determine if the required door options is a inoperable (fixed style) or operable (cabinet style). Doors denoted with an FS are inoperable. Doors denoted with an CS are operable. Refer to Section 13.E for door information.

2.Bend the left and right side templates for the appropriate door type using Figure 13.2 as a reference.

3.Locate the four threaded inserts on the inside edge of the fireplace and secure the side templates with the Phillips screws provided. See Figure 13.3.

4.Bend the top template as shown in Figure 13.1 and secure with the two screws provided. The bend will have two opposing 90 degree bends, similar to the bends on the side templates.

5.Remove all template components once finishing materials are secured.

3/4 IN.

1-1/2 IN.

INOPERABLE OPERABLE

DOORSDOORS

Figure 13.2 Left and Right Side Finishing Template Bends

TOP FINISHING

TEMPLATE

SIDE FINISHING

TEMPLATES

Figure 13.3 Top and Side Finishing Template Locations

Note: A thin layer of mortar may be applied over the visible non-combustible board between finishing material and the fireplace opening.

1-1/4 IN.	TAB
	INOPERABLE DOORS - BEND DOWN
	OPERABLE DOORS - DO NOT BEND DOWN

Figure 13.1 Top Finishing Template Bend

Heatilator • HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12 47