Heatiator HEIR42T, HEIR42H, HEIR50T, HEIR36H, HEIR36T, HEIR50H owner manual Listing and Code Approvals

1 Listing and Code Approvals

A. Appliance Certification

MODELS: HEIR36H, HEIR36T HEIR42H, HEIR42T HEIR50H, HEIR50T

LABORATORY: Underwriters Laboratories, Inc. (UL)

TYPE: Direct Vent Gas Appliance Heater

STANDARD: ANSI Z21.88-2009 • CSA 2.33-2009

This product is listed to ANSI standards for “Vented Gas Appliance Heaters” and applicable sections of “Gas Burn- ing Heating Appliances for Manufactured Homes and Recreational Vehicles”, and “Gas Fired Appliances for Use at High Altitudes”.

NOTICE: This installation must conform with local codes. In the absence of local codes you must comply with the National Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. and the CAN/CGA B149 Installation Codes in Canada.

NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE. This appliance is tested and approved as either supplemen- tal room heat or as a decorative appliance. It should not be factored as primary heat in residential heating calculations.

D. High Altitude Installations

NOTICE: If the heating value of the gas has been reduced, these rules do not apply. Check with your local gas utility or authorities having jurisdiction.

When installing above 2000 feet elevation:

•In the USA: Reduce input rate 4% for each 1000 feet above 2000 feet.

•In CANADA: Reduce input rate 10% for elevations between 2000 feet and 4500 feet. Above 4500 feet, consult local gas utility.

Check with your local gas utility to determine proper orifice size.

E. Non-Combustible Materials Specification

Material which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136,

Standard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750 ºC and UL763 shall be considered non-combustible materials.

B. Glass Specifications

This appliance is equipped with 5 mm ceramic glass. Re- place glass only with 5 mm ceramic glass. Please contact your dealer for replacement glass.

C. BTU Specifications

Models		Maximum	Minimum	Orifice
		Input	Input	Size
(U.S. or Canada)		BTU/h	BTU/h	(DMS)
	US	45,500	27,000	#30
HEIR36 (NG)	(0-2000 FT)
	CANADA	41,000	24,500	#31
	(2000-4500 FT)
	US	44,000	27,000	#47
HEIR36 (LP)	(0-2000 FT)
	CANADA	39,500	24,500	#48
	(2000-4500 FT)
	US	54,000	30,000	#26
HEIR42 (NG)	(0-2000 FT)
	CANADA	48,500	27,000	#27
	(2000-4500 FT)
	US	51,500	29,500	#45
HEIR42 (LP)	(0-2000 FT)
	CANADA	46,500	26,500	#46
	(2000-4500 FT)
	US	65,000	36,000	#24
HEIR50 (NG)	(0-2000 FT)
	CANADA	58,500	32,500	#25
	(2000-4500 FT)
	US	63,500	32,500	#43
HEIR50 (LP)	(0-2000 FT)
	CANADA	57,000	29,500	#44
	(2000-4500 FT)

F. Combustible Materials Specification

Materials made of or surfaced with wood, compressed pa- per, plant fibers, plastics, or other material that can ignite and burn, whether flame proofed or not, or plastered or unplastered shall be considered combustible materials.

G. Electrical Codes

NOTICE: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70-latest edition or the Canadian Electric

Code CSA C22.1.

•A 110-120 VAC circuit for this product must be pro- tected with ground-fault circuit-interrupter protection, in compliance with the applicable electrical codes, when it is installed in locations such as in bathrooms or near sinks.

Heatilator • HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12 7