Heatiator HEIR42H H. Fixed Glass Assembly, Glass Weights, HEIR36, HEIR50, 32 lbs, 41 lbs, 54 lbs

H. Fixed Glass Assembly

WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.

•DO NOT strike, slam or scratch glass.

•DO NOT operate fireplace with glass removed, cracked, broken or scratched.

•Replace as a complete assembly.

WARNING! Risk of Injury! Glass assembly installation and removal must be performed by a qualified service technician. See chart below for glass assembly weights.

•HEIR42 AND HEIR50 MODELS: It is recommended that Glass installation and removal be performed by two qualified service technicians.

Glass Weights

HEIR36	HEIR42	HEIR50
32 lbs	41 lbs	54 lbs

CAUTION! Risk of Cuts or Abrasions. Wear protective gloves and safety glasses during installation. Sheet metal edges are sharp.

Removing Fixed Glass Assembly

This fixed glass assembly is held in place by lower glass clips, side clips and top retaining rail. To remove clips, en- gage the spring clips with the tool and pull tool out slightly.

1.The glass clip removal/installation tool is fastened to the lower right corner of the fireplace. Remove tool by removing one screw. See Figure 14.3. If glass clip removal tool becomes misplaced, a cotter pin removal tool may be used. Replace glass clip removal/instal- lation tool in same place with the one screw after use.

NOTICE: Protect and prevent the hearth from damage by covering it with a drop cloth.

Figure 14.4. Glass Clip Tool Location

2.To disengage bottom glass clips, position the glass clip removal/installation tool parallel to the floor and insert it about two inches into the gap between the glass frame and the front bottom fireplace lip. Insert the tool on the lower left side of the glass clip and move to the right to engage the clip. Using one mo- tion, pull out slightly while pushing down to disengage bottom glass clip. Repeat for the other bottom spring clips. There are three on the HEIR36 and four on the HEIR42 and HEIR50. See Figure 14.5.

Figure 14.5 Inserting Glass Clip Tool

3.Disengage the left and right glass clips one at a time using the glass clip removal/installation tool. Insert tool from the top side of the side glass clip. Pull the glass tool out slightly to disengage the side clip. See Figure 14.9.

4.Grasp the left and right sides of the glass assembly and carefully pull outward to remove the bottom from the support tabs on the bottom glass clips. Lower the glass to remove it from the top retainer rail.

CAUTION! Risk of Injury! DO NOT put fingers under glass frame. Fingers may get pinched by glass frame during removal.

Figure 14.3. Glass Clip Tool

60 Heatilator • HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12