![](/images/new-backgrounds/1071097/710977x1.webp)
Model
2-4. COMPLETE CONTROL
PANEL REPLACEMENT Should the control board become inoperative, follow these instructions for replacing the board.
1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move the POWER switch to OFF and disconnect main circuit breaker, or unplug cord at wall receptacle.
2.Remove the four screws securing the control panel and lift out.
3.Unplug the wire connectors going to the control board.
4.Install new control panel in reverse order.
When plugging connectors onto new control panel, be sure the connectors are inserted onto all of the pins, and that the connectors are not forced onto the pins backwards. If not connected properly, damage to the board could result.
To avoid electrical shock or property damage, move the POWER switch to OFF and disconnect main circuit breaker, or unplug cord at wall receptacle.
2.Remove control panel.
3.Label and remove the wires from the switch. With test instrument, check across the terminals of the switch with the switch in the ON position, then in the OFF position. With the switch in the ON position, the circuit should be closed. With the switch in the OFF position, the circuit should be open. If the switch checks defective, replace by continuing with this procedure.
203 |