5K320 SATA OEM Specification
4.4.2Mechanical positioning
4.4.2.1Average seek time (including settling)
Command Type | Typical (ms) | Max. (ms) |
Read | 12 | 14 |
Write | 13 | 15 |
Table 5. Mechanical positioning performance
Typical and Max. are defined throughout the performance specification as follows:
Typical Average of the drive population tested at nominal environmental and voltage conditions.
Max. Maximum value measured on any one drive over the full range of the environmental and voltage conditions. (See section 6.1, "Environment" and section 6.2, "DC power requirements" )
The seek time is measured from the start of motion of the actuator to the start of a reliable read or write operation. A reliable read or write operation implies that error correction/recovery is not employed to correct arrival problems. The Average Seek Time is measured as the weighted average of all possible seek combinations.
max.
Σ (max. + 1 – n)(Tni n + Tn out)
n=1
Weighted Average =
(max. + 1)(max)
Where: max. = maximum seek length n = seek length
Tnin | = inward measured seek time for an |
Tnout | = outward measured seek time for an |
4.4.2.2Full stroke seek
Command Type | Typical (ms) | Max. (ms) |
Read | 20.0 | 25 .0 |
Write | 21.0 | 26 .0 |
Table 6. Full stroke seek time
Full stroke seek time in milliseconds is the average time of 1000 full stroke seeks.
4.4.2.3Single track seek time (without command overhead, including settling)
Command Type | Typical (ms) | Maximum (ms) |
Read | 1.0 | 2.0 |
Write | 1.1 | 2.2 |
Table 7. Single track seek time
Single track seek is measured as the average of one (1) single track seek from every track in both directions (inward and outward).
4.4.2.4Average latency
Rotational Speed | Time for one revolution | Average Latency |
(RPM) | (ms) | (ms) |
5400 | 11.1 | 5.5 |
Table 8. Latency time
19
