Hitachi L100 instruction manual Output Terminal Configuration, Out-Tm

L100 Inverter

3–31

Output Terminal Configuration

The inverter provides configuration for logic (discrete) and analog outputs, shown in the table below.

	“C” Function		Run-	Defaults		DOP,DRW,DOP+
Func.	Name	Description	time	EU/	Units	Func.	Name
			Edit
Code				US		Code
C21	Terminal 11 function	Select function for terminal 11,	✘	01	—	F-35	OUT-TM
	(logical)	6 options (see next section)					1
C22	Terminal 12 function	Select function for terminal 12,	✘	00	—	F-35	OUT-TM
	(logical)	6 options (see next section)					2
C23	Terminal FM function	Select function for terminal	✘	00	—	F-37	MONITOR
	(analog)	FM, 3 options (see next
		section)

The output logic convention is programmable for terminals 11 and 12. The open-collec- tor output terminals 11 and 12 default to normally open (active low), but you can select normally closed (active high) for terminals 11 and 12 in order to invert the sense of the logic. The relay already has normally open and normally closed contacts, but you can invert the logic sense of these as well.

	“C” Function			Run-	Defaults		DOP,DRW,DOP+
Func.	Name		Description	time	EU/	Units	Func.	Name
				Edit
Code					US		Code
C31	Terminal 11 active	Select logic convention, two		✘	00	—	F-35	OUT-TM
	state	option codes:						O/C-1
		00	... normally open [NO]
		01	... normally closed [NC]
C32	Terminal 12 active	Select logic convention, two		✘	00	—	F-35	OUT-TM
	state	option codes:						O/C-2
		00	... normally open [NO]
		01	... normally closed [NC]
C33	Alarm relay active	Select logic convention, two		✘	01	—	F-35	OUT-TM
	state	option codes:						O/C-RY
		00	... normally open [NO]
		01	... normally closed [NC]

Drive Parameters Configuring