Hitachi L100 Specifications of Control and Logic Connections, Analog Logic Inputs Output Outputs

L100 Inverter

4–5

Specifications of Control and Logic Connections

The control logic connectors are located just behind the front panel half-door. The relay contacts are accessible behind the main door. Connector labeling is shown below.

Logic inputs

L 5 4 3 2 1 P24

H O OI	L FM CM2 12 11
Analog
	Analog	Logic
Inputs	Output	outputs

AL0 AL1 AL2

Relay

contacts

Specifications for the logic connection terminals are in the following table:

Terminal Name	Description	Ratings
P24	+24V for logic inputs	24VDC, 30 mA max (do not short to terminal L)
1, 2, 3, 4, 5	Discrete logic inputs	27VDC max. (use P24 or an external supply refer-
		enced to terminal L)
L (top row) *1	GND for logic inputs	sum of input 1-6 currents (return)
11, 12	Discrete logic outputs	50mA maximum ON state current,
		27 VDC maximum OFF state voltage
CM2	GND for logic outputs	100 mA: sum of 11 and 12 currents (return)
FM	PWM (analog/digital) output	0 to 10VDC, 1 mA, PWM and 50% duty digital
L (bottom row) *1	GND for analog inputs	sum of OI, O, and H currents (return)
OI	Analog input, current	4 to 19.6 mA range, 20 mA nominal
O	Analog input, voltage	0 to 9.6 VDC range, 10VDC nominal,
		input impedance 10 kΩ
H	+10V analog reference	10VDC nominal, 10 mA max
AL0	Relay common contact	250 VAC, 2.5A (R load) max.,
		250 VAC, 0.2A (I load, P.F=0.4) max.
AL1	Relay contact, normally
		100 VAC, 10mA min.
	closed during RUN
		30 VDC, 3.0A (R load) max.
AL2	Relay contact, normally open	30 VDC, 0.7A (I load, P.F.=0.4) max.
	during RUN	5 VDC, 100mA min.

Operations and Monitoring

Note 1: The two terminals “L” are electrically connected together inside the inverter.