Hitachi L200 manual 240

B–24

ModBus Data Listing

The table below lists the holding registers for the “F” Group Main Profile Parameters.

		Holding Registers, “F” Group Main Profile Parameters
	Func.	Name	R/W	Description		Network Data
	Code				Reg.		Range	Res.
	F001	Output frequency	R/W	Standard default target	0023h		0 / (start	0.1 Hz
		setting		frequency that determines			freq. x 10)
				constant motor speed,			to 4000
				range is 0.0 / start frequency
				to 400 Hz
B	F002	Acceleration (1) time	R/W	Standard default acceleration,	0024h		1 to	0.01
	(high)	setting *1		range is 0.01 to 3000 sec.			300000	sec
Appendix		setting, 2nd motor *1		2nd motor,			300000	sec
	(high)		R/W		0025h
	F002
	(low)
	F202	Acceleration (1) time	R/W	Standard default acceleration,	0026h		1 to	0.01
				range is 0.01 to 3000 sec.
	F202		R/W		0027h
	(low)
	F003	Deceleration (1) time	R/W	Standard default deceleration,	0028h		1 to	0.01
	(high)	setting *1		range is			300000	sec
				0.01 to 3000 sec.
	F003		R/W		0029h
	(low)
	F203	Deceleration (1) time	R/W	Standard default deceleration,	002Ah		1 to	0.01
	(high)	setting, 2nd motor *1		2nd motor,			300000	sec
				range is 0.01 to 3000 sec.
	F203		R/W		002Bh
	(low)
	F004	Keypad Run key routing	R/W	Two options; select codes:	002Ch		0, 1	—
				00... Forward
				01... Reverse

Note 1: When the value is 10000 (100.0 seconds), a value in the second decimal place is ignored.