Hitachi L200 d 0 0, A – – –, TM/PRG DIP Switch Setting, Prepare to Edit Parameters, Selecting Functions and Editing Parameters, Select the Potentiometer for Speed Command

2–26

Using the Front Panel Keypad

Inverter Mounting and Installation

Selecting Functions and Editing Parameters

To prepare to run the motor in the powerup test, this section will show how to configure the necessary parameters:

1.Confirm the TM/PRG DIP switch setting.

2.Select the keypad potentiometer as the source of motor speed command (A001)

3.Select the keypad as the source of the RUN command (A002)

4.Set the inverter’s maximum output frequency to the motor (A003)

5.Set the motor current for proper thermal protection (B012)

6.Set the inverter’s Automatic Voltage Regulation for the motor (A082)

7.Set the number of poles for the motor (H004)

The following series of programming tables are designed for successive use. Each table uses the previous table’s final state as the starting point. Therefore, start with the first and continue programming until the last one. If you get lost or concerned that some of the other parameters settings may be incorrect, refer to “Restoring Factory Default Settings” on page 6–8.

TM	TM/PRG DIP Switch Setting - This switch must be in the “PRG” position
	(factory default) in order for A001 and A002 settings to be active. Other-
	wise, the keypad will be unable to accept a Run command or set the motor
	speed with the potentiometer. If the switch setting has been changed, see the
	“DIP Switch Introduction” on page 2–5.
PRG

Prepare to Edit Parameters - This sequence begins with powering ON the inverter; then it shows how to navigate to the “A” Group parameters for subsequent settings. You can also refer to the “Keypad Navigational Map” on page 2–25 for orientation throughout the steps.

	Action	Display	Func./Parameter
Turn ON the inverter.		0.0	Inverter output frequency
			displayed (0Hz in Stop Mode).
Press the FUNC.	key.	d 0 0 1	“D” Group selected
Press the 2	key four times.	A – – –	“A” Group selected

Select the Potentiometer for Speed Command -

Potentiometer Enable LED

The inverter output frequency can be set from several sources, including an analog input, memory setting,

HITACHI

POWER

or the network, for example. The powerup test uses the keypad potentiometer as the speed control source for your convenience. In the figure to the right, notice the Potentiometer Enable LED, just above the knob. If the LED is ON, the potentiometer is already selected as the source, and you may skip this step. Note that the default setting depends on the country.

HzALARM

5 0.0 A

RUN

STOP PRG

RUN RESET

FUNC. 1 2 STR