![](/images/new-backgrounds/1055808/5580827x1.webp)
Operation | SDC / DHC |
|
|
4.1.2Operating elements
4.1.2.1Input button (press / turn)
ðBy pressing once, you can:
• Confirm input / values
By pressing and holding (approx. 3 s), you can:
•Switch to the
•Move up one menu level
By turning the input button î, you can:
•Change values (clockwise increases
•Navigate through menus
4.1.2.2"Daytime room temperature" button
Sets the desired room temperature (room setpoint) in automatic
¥mode during the heating cycles and in the PARTY and HEATING operating modes. In operating mode 1, the set value for all heating circuits is the same. In operating mode 2, the set value applies for the respective heating circuit. To set the operating mode, see 4.2.3.3 Operating mode, pg. 52.
Setting ► Press ¥ button.
►Set flashing room temperature specification to the desired value by turning the input button î.
C
|
|
| ► Confirm set value by pressing the ¥ button or the input |
|
|
| |
|
|
| button î. |
|
|
| Alternative: Automatic acceptance of the value after the set |
|
|
| information time (see 4.1.2.7 "System information" button, pg. 26). |
| Factory setting | 20 °C | |
| Setting range | 5 ... 30 °C |
14 |