![](/images/new-backgrounds/1055808/5580885x1.webp)
SDC / DHC | Operation |
|
|
4.2.2.4.3.2Copying switching time programs (heating circuits)
Source circuit
Target circuit
NOTE
Block programming also enables the copying of all switching times and temperature specifications of a heating circuit to another heating circuit.
Calling up the copy function (heating circuits)
See flowcharts on pg. 44
►Press input button î to confirm the copy function.
►Turn input button î to select the source circuit to be copied (HC,
If automatic program P1, P2 or P3 (see "System Parameter" menu, PROGRAM parameter = P1 to P3) was enabled, the desired switching time program P1, P2 or P3 of the source circuit can be selected. If not enabled, program selection is skipped.
►Press input button î, to confirm the source circuit. Based on the same chart, the desired target circuit and, if enabled, the desired program can be selected and accepted.
Acceptance is confirmed by acknowledging COPY OK. The copy function is then called up again to copy additional circuits, if necessary.
Heating circuits cannot be copied to
A
Pressing the button causes an immediate return to the basic display.
| 43 |