NOTE The switch-off time cannot be set higher than the switch-on time of a subsequent cycle.
If the switch-on time is changed, the corresponding time bar display is adjusted to the right-hand side.
If the switch-off time is made equal to the switch-on time, the corresponding cycle is deleted. A subsequent cycle is automatically shifted to the position of the deleted cycle upon acceptance.
With subsequent insertion of a cycle that has been bumped up, the corresponding day of the week must be reprogrammed.
A flashing switch-off time is accepted by pressing the input button î.
4.2.2.4.3Cycle temperature
Once the switch-off time is accepted, the associated cycle temperature appears flashing and can be changed immediately with the input button î. With heating circuits, the displayed cycle temperature is always based on the desired room temperature; with the hot-water circuit, it is based on the desired normal hot- water temperature in the selected cycle.
A flashing cycle temperature is accepted by pressing the input button î.
At the same time, the last called-up cycle appears flashing so that it may be monitored; additional cycles can then be selected directly and edited in the same way in the order: switch-on time, switch-off time, cycle temperature.
