Honeywell SDC manual Time program, Operating mode Setting range Set values

Operation SDC / DHC

4.2.3.2Time program

This parameter specifies enabling of the switching time programs for program selection and for individualised switching time programming. In the state of delivery, only one switching time program is enabled. This achieves simplification of operation with a large portion of applications for which only one switching time program is used.

Set values

Factory setting Effects

P1 Program 1 = enabled, programs 2 and 3 = disabled

P1 All three programs enabled to P3

P1

In contrast to the previous description, the following setting options are available when programs P1 to P3 are enabled:

•Operating mode selection: In the AUTOMATIC and SUMMER operating modes, switching time program P1, P2 or P3 can be selected.

•Switching time programming: With switching time pro- gramming, the three switching time programs, P1 to P3, can be selected for each heating circuit.

4.2.3.3Operating mode

Setting range

Set values

Two operating modes can be selected. They determine whether the operating mode, the daytime temperature and the night-time temperature apply for all heating circuits or can be specified individually for each heating circuit.

1, 2

1The selected setting applies for all heating circuits together.

2Each heating circuit can be assigned an individualised set- ting.

Factory setting 1

52 EN2H-0220GE51 R0308