Honeywell SDC manual Setting Application, Absence mode short-term program

Operation SDC / DHC

Setting

Return to the basic display

NOTE

4.1.2.5.1

Setting

Application

18

The selected operating mode appears in plain text, whereby a marking at the bottom edge of the display points to the respective operating mode symbol at the same time. In operating mode 1, the set value for all heating circuits is the same. In operating mode 2, the set value applies for the respective heating circuit. To set the operating mode, see 4.2.3.3 Operating mode, pg. 52.

►Press button.

►Select operating mode by turning the input button î. The marking is located above the corresponding operating mode symbol.

►Confirm set operating mode by pressing the button or the input button î.

►With short-term operating modes (ABSENT, PARTY), set the desired value by turning the input button î and confirm with

the button or the input button î.

Alternative: Automatic acceptance of the value after the set information time (see 4.1.2.7 "System information" button, pg. 26).

Press the button for approx. 3 s to return to the basic display from any operating level.

Holiday mode is set via the "Switching time programs / Holiday programs" button (see 4.1.2.6 "Switching time programs / Holiday programs" button, pg. 23).

Absence mode (short-term program)

With the ABSENT operating mode, heating operation is temporarily deactivated and protected from frost during brief absences. During the absence, all heating circuits are adjusted to the specified lowered room temperature. Once the set time expires, the heating circuits automatically return to the operating mode that was active before the switch to the absence operation. Short-term programs such as PARTY or ABSENT are skipped here.

See 4.1.2.5 "Operating mode" button (basic display) , pg. 16

Short absence while heating operation is active.

EN2H-0220GE51 R0308