Manuals / Honeywell / Household Appliance / Thermostat

Honeywell SDC manual Selection of the control circuit, Selection of the program

Models: SDC

1 64

Download 64 pages 29.07 Kb

Page 35

SDC / DHC	Operation

4.2.2.1Selection of the control circuit

After accessing the "Timeprograms" menu, the desired control circuits can be selected with the input button î in the following sequence:

•Direct heating circuit (HC)

•Mixed heating circuit 1 (MC-1)

•Mixed heating circuit 2 (MC-2)

•Hot-water circuit (DHW)

► Press input button î to access the selected circuit.

4.2.2.2Selection of the program

If the switching time programs P2 and P3 have been enabled (see "System Parameter" menu, program parameter = P1 to P3), the program selection appears.

If switching time programs P2 and P3 are disabled, program selection is automatically skipped (see "System Parameters" menu, program parameter = P1).

4.2.2.3Selection of day of the week and cycle

Once the program is selected, the first cycle of the first day of the week (MO 1) and the relevant section in the top time bar flash. The other cycles are selected by turning the input button î and confirmed by pressing the input button î.

EN2H-0220GE51 R0308

35

Image 35

Honeywell SDC manual Selection of the control circuit, Selection of the program, Selection of day of the week and cycle

Contents

Heating Controller SDC Remote Heating Controller DHC EN2H-0220GE51 R0308 Contents Log ContentsSDC / DHC Page Intended use Software versionCable cross-sections Power supplyCable installation Connection conditionsGrounding and zeroing Hot-water temperature greater than 60 CSDC / DHC SDC 12-31 TypeBurnerstage 2 or Districtheating valve Closed Display and operating elements OperationDisplay basic display Operating elements Input button press / turn Daytime room temperature buttonFactory setting Setting rangeFactory setting 50 C Night-time room temperature buttonSetting Daytime hot-water temperature buttonOperating mode button basic display Absent Absence mode short-term program 2.5.1 Setting ApplicationP1 P2, P3 Party mode short-term programAutomatic mode Manual summer operation excluding heating operation Display Disabling / enabling default program P2 to P3Disabling / enabling default programs P2 to P3 EnablingContinuous lowering operation Continuous heating operationSwitching time programs / Holiday programs button Standby modeHoliday mode Factory setting Current date System information button Operating overview Manual mode / Emission measurement button Setting range Factory settingCancellation 2.9 Setting Setting range Heating curve Menu-selection level Menu functions are described in the following Returning AccessTime Date menu Timeprograms menu Access Returning Selection of day of the week and cycle Selection of the control circuitSelection of the program Switch-off time Cycle temperature DHW Switching time programming programs P2 and P3 disabledDefault program P1 Default switching time program P1 for heating and hot waterSwitching time programming program P2 and P3 enabled Default program P3 Default program P2Calling up the copy function days Copying switching time programs days Source day Target dayCalling up the copy function heating circuits Block programming SDC / DHC Copying heating circuits Reloading default programs SDC / DHC Reloading default programs Switching time programs P2 and P3 enabled Language selection System Parameters menu Access ReturningSetting values DE Factory setting GermanSet values Operating mode Setting range Set valuesTime program 30 C Summer / Heating limit Quick increase in outside temperatureSlow increase in outside temperature Undoing deactivation Factory setting 20 CParameter reset DHW menu Night-time hot-water temperatureFactory setting 40 C Set values RED lowering operation Reduced operationHeating system ECO switch-off operationRadiator systems Time Setpoint Opt Wed Cont. circuit Thu Fri Sat Sun LogSDC / DHC SDC / DHC Page Automation and Control Solutions